Purpose
The raw impulse response contains direct sound + room. Windowing selects which portion is FFT'd to produce the frequency response. Short window = quasi-anechoic (direct only, poor LF resolution). Long window = in-room (with reflections, good LF resolution). Choose based on question you're asking.
Numbered Workflow
- Make sweep: Measure → SPL → 20Hz–20kHz, 256k sweep, -12dBFS, timing reference if comparing phase.
- SPL & Phase: Open graph. Apply Variable smoothing for EQ work (preserves LF detail, smooths HF). Avoid 1/3-oct smoothing at LF — it hides modal peaks.
- Impulse: Open Impulse graph. Identify direct spike (t=0), early reflections (first 20ms), and noise floor. ETC view (envelope) helps spot reflections.
- IR Windows: Click IR Windows. Set Left window (before peak, typically 125ms Hann) and Right window (after peak, e.g. 500ms for in-room, 5ms for quasi-anechoic). Window type matters: Hann/Tukey are common; rectangular is sharpest but has sidelobes.
- Apply & observe: Apply windows → SPL response updates. Short right window = smoother, less LF resolution, jagged if too short. Long = more LF detail but includes room.
- FDW (optional): Add Frequency-Dependent Window — width varies with frequency (narrower at HF). Useful for quasi-anechoic that still shows LF room. Set in cycles or octaves.
- Check validity: Rule:
f_min ≈ 1 / window_duration. 10ms window → valid only above ~100Hz. REW can show dashed line below limit via Show response below window limit.
Interactive: Window Duration vs LF Validity
Valid above: 20 Hz • Below this, response is dashed/interpolated, not measured.
Try: 5ms (quasi-anechoic, valid >200Hz) vs 500ms (in-room, valid >2Hz). For sub work you need ≥500ms.
Outputs & Interpretation
- SPL trace: Peaks = modes or speaker resonances. Dips = cancellations (SBIR, crossover, interference). Don't EQ dips.
- Phase trace: Wraps at ±180°. Look at group delay instead for readability. Constant slope = pure delay.
- Window indicators: Shaded regions on IR show what's included. Windowed trace = data actually FFT'd.
- Step response: Integral of IR. Useful for driver polarity/time alignment — ideal step rises quickly and stays.
Deeper Detail — Window Types & 96 PPO
Left vs Right: Left window is before IR peak (pre-ring, usually short). Right window is after peak (contains reflections/decay). Most adjustment is right side.
Types: Hann (smooth), Tukey (flat top + tapered edges), Rectangular (no taper, best resolution but high sidelobes), Blackman-Harris, etc. Hann is safe default.
FDW: E.g. 6 cycles at LF, 1/6 oct at HF. Gives frequency-dependent resolution matching hearing. Good for speaker design quasi-anechoic.
96 PPO: REW converts to 96 points per octave log spacing for display — ensures even visual density across log frequency axis.
Common error: Using 10ms window and trying to EQ 30Hz. The data below ~100Hz is invalid — you're EQing interpolation.
Check Your Understanding
You use a 8ms right window to get a clean quasi-anechoic speaker response. What can you validly conclude about 40Hz?